Today we introduce a fault that is very easy to cause misjudgment. That is why the driver does not accelerate or the acceleration is very slow during the use of the compressed garbage truck when the driver steps on the accelerator.
For this first reaction, we will consider whether the accelerator controller of the chassis part has failed. This is the first time we must consider, but with the advancement of technology, we have adopted the control of the failure of the compressed garbage truck in the past few years. With the deepening of electrical control of machinery, the current diesel engine models are also controlled by the driving computer. At present, our modification plant has abandoned the traditional throttle control of compressed garbage trucks at work. The mechanical operation is based on the electrical control system, which automatically increases or decreases the throttle according to the movement of the vehicle.
Because the control system is connected to the throttle control system of the chassis, we first check the control system of the chassis when troubleshooting. If there is no fault, then we need to consider whether the controller is faulty.
Here we teach you a simple method, because our controller is connected to the controller above the chassis with two wires, we just need to use a screwdriver to remove the controller installed in the factory and then start the vehicle Observe whether the fault of the gas pedal is resolved. If it is judged that the controller installed in the modification factory is faulty, then we can contact the manufacturer to send a new replacement fault to solve it.